Reference · Equipment
Pickleball overgrip vs replacement grip
Updated
What separates an overgrip from a replacement grip, how much each changes grip size, how often players are told to change them, what the 2026 rulebook allows, and how to wrap both.
An overgrip is a thin wrap (CRBN lists its DryTec overgrip at 0.6 mm) that goes on top of the paddle's existing grip and is changed every few weeks to every couple of months; a replacement grip is the thicker, cushioned base wrap (1.75 to 1.9 mm on HEAD and Paddletek spec sheets) that goes directly on the handle after the old one is cut off, and it lasts much longer. One layer of overgrip builds the grip up by about 1/16 inch. Both are legal: USA Pickleball's 2026 rulebook lists "addition or replacement of grip wrap" as an allowed alteration (Rule 3.D.6.h), as long as the paddle still meets all specifications.
Overgrip vs replacement grip: chart
| Feature | Overgrip | Replacement grip |
|---|---|---|
| What it is | "A thin, soft, slightly padded grip that is placed over the existing grip" (JustPaddles); adds tack, absorbs sweat, minor cushioning (pickleball.com) | "Thicker and more padded," installed directly on the paddle (JustPaddles); the cushioned covering every paddle ships with, "sometimes called a replacement grip" (Selkirk) |
| Goes on | Over the base grip; remove the old overgrip, but not the base grip (JustPaddles) | The handle itself, after the old grip is cut off and leftover adhesive scraped away (Selkirk) |
| Thickness, examples | CRBN DryTec 0.6 mm; HEAD Xtreme Soft "very thin" | HEAD Hydrosorb Pro 1.75 mm; Paddletek AeroTac Pro 1.9 mm; Tourna Cushion "a thicker version of a standard grip" |
| Grip size added | About 1/16 in per layer (Pickleball Galaxy); "minimal compared to replacing the entire grip" (Franklin overgrip listing, Pickleball Central) | Depends on the new grip versus the old one; Gamma says its replacement grips stretch, so tension controls the thickness |
| How often to change | Every few weeks for active players (pickleball.com, JOOLA); after 6 to 8 matches (PB5star); every couple of months for casual players (JOOLA) | "Annually or whenever it feels slippery" (Pickleball Central); lasts "significantly longer than an overgrip" (JustPaddles) |
| Comes with | Finishing tape (Franklin's 3-pack includes three); most have an adhesive strip at the tapered tip, though a Tourna Grip has neither taper nor adhesive (Pickleball Warehouse) | An adhesive backing under a protective strip, and finishing tape in the package (Selkirk) |
| Rule | 3.D.6.h: "Addition or replacement of grip wrap" | 3.D.6.h for a wrap; 3.D.6.d for "OEM interchangeable grips" |
Pickleball Central's rule of thumb: a regular grip layered over the original adds bulk, but "if you're only looking to alter the tackiness, stick to an overgrip."
How each one changes grip size
The rulebook sets no grip circumference; sizes are maker labels (see the paddle weight and grip size guide for how to measure your hand). Pickleball Galaxy says "1 layer of an overgrip builds the grip up by about 1/16 of an inch" and lists grip sizes in 1/8-inch steps, from 4 in to 4 5/8 in, so one layer is about half a size step. How tightly you wrap matters too: "The tighter you pull, the thinner it will feel" (Pickleball Warehouse).
Size only goes one way. A grip can be built up with overgrips until it reaches the thickness you want, but it cannot be made smaller (Pickleball Galaxy), which is why grip-size guides say to choose the smaller size when you fall between two. Selkirk's Stephen Bass adds that if you often put overgrip on, you should factor that into the grip size you buy. Players who want to keep a handle slim can pick a thin overgrip: Pickleball Central's listing for HEAD's Xtreme Soft overgrip says its "super thin design helps keep your grip circumference down." The rulebook also allows size changes "via inserts" (Rule 3.D.6.g).
How to put on an overgrip
- Start at the butt cap.
- Wind upward in a spiral.
- Overlap each turn slightly.
- Trim and tape at the top.
- Tape on the face: at most 1.0 in above the grip (Rule 3.D.7).
- Direction by playing hand (Selkirk).
- Remove the old overgrip only. JustPaddles: "do not remove the replacement grip that's currently on the handle!" If there is a rubber band at the top of the handle, take it off and keep it (JOOLA).
- Unroll the new overgrip and peel off the plastic film and the backing on the tapered end (Pickleball Warehouse, JOOLA).
- Start at the butt cap. Stick the starting end at the base of the handle and wrap once around (JOOLA); Pickleball Warehouse places the tapered end on a short bevel, angled upward.
- Pull in your hand's direction. Looking down at the butt cap, "right-handed players pull the grip to the right, while left-handed players pull to the left" (Selkirk). Pickleball Galaxy's answer to a left-handed player is the same: wrap the opposite direction.
- Wind up the handle at about 70 to 80 percent tension (Selkirk), overlapping each turn. Sources give different overlaps: about 1/16 in (Pickleball Warehouse), about half a centimeter (JOOLA) and about 3/8 in "to build even thickness" (PB5star).
- Trim and tape. Cut the end on a slight angle at the top and secure it with finishing tape (PB5star) or a rubber collar (Selkirk), then put the band back on (JOOLA).
- Test it with a few swings: no slipping or bunching (PB5star).
How to replace the base grip
Selkirk's replacement steps:
- Cut the old grip off along its length with a utility knife or scissors, peel it away and scrape off leftover adhesive. Go slowly on an old grip so the handle is not damaged.
- Clean the handle with a damp cloth to remove dirt and sweat.
- Prepare the new grip: take off the plastic and stickers, roll it out flat to check for twists or creases, and find the tapered end, which is where you start.
- Wrap from the bottom of the handle after peeling the protective strip, spiraling up with a slight overlap and pressing firmly. If a turn goes wrong, peel back to the last good section and redo it.
- Trim the excess at the top and bottom and secure the top with the finishing tape from the package.
Weighted tape on the handle can stay under the new wrap, since both are allowed alterations (see lead tape placement). An overgrip can then go on top of the new base grip.
When to change each
| Wrap | Signs it is time, as sources list them |
|---|---|
| Overgrip | Less tack, slipperiness in warm or sweaty conditions, visible fraying at the edges (pickleball.com); a colour change or lost surface tack (JOOLA); a slick feel mid-rally, visible wear, the handle shifting on quick shots (PB5star) |
| Replacement grip | Cracks, tears, wear, discoloration or residue, less cushioning, slipping in the hand, or needing to adjust it often (Selkirk) |
A slippery grip is a grip problem, not a sign the paddle itself is worn out; see how long pickleball paddles last for the signs that do mean replacing the paddle, and how to clean a pickleball paddle for wiping the grip between changes.
What the 2026 rulebook allows
| Rule | What it says |
|---|---|
| 3.D.6 | "Altered paddles must meet all specifications," and the listed changes are "the only allowable alterations or additions by a player" |
| 3.D.6.h | "Addition or replacement of grip wrap"; the rule does not separate overgrips from base grips |
| 3.D.6.d | "Replacement of OEM interchangeable grips" |
| 3.D.6.g | "Changes to the grip size via inserts" |
| Section 2 definitions | Paddle grip adjustments: "Non-mechanical devices that change the size of the grip or stabilize a player's hand on the grip" |
| 3.D.7 | Decals and tape on the paddle face may reach no more than 1.0 inch above the top of the grip |
For the full paddle rules and the approved list, see pickleball paddle specs; for hand positions on the handle, see how to hold a pickleball paddle.
Overgrip checklist
- Tack or sweat problem only: add or change an overgrip; leave the base grip on.
- Base grip cracked, torn or flat: cut it off, clean the handle, wrap a replacement grip.
- Grip too small: build it up with overgrip, about 1/16 in per layer; it cannot be made smaller.
- Pack a spare overgrip and finishing tape in the bag (see the tournament checklist).
Sources
- USA Pickleball — 2026 Official Rulebook, copy hosted by Pickleball Canada (Section 2 definitions, Rules 3.D.6, 3.D.7)
- pickleball.com — What is an overgrip in pickleball? (help article)
- JustPaddles — Difference between a pickleball overgrip and a replacement grip (July 17, 2024)
- Selkirk University — How to replace the grip on a pickleball paddle
- Selkirk University — How to overgrip your pickleball paddle for maximum performance
- Selkirk — Grip it and rip it: grips and lead tape (Stephen Bass, September 20, 2023)
- Pickleball Galaxy — How to choose a pickleball paddle grip size
- Pickleball Galaxy — Q&A: should a left-handed player's grip be wrapped the opposite direction? (August 26, 2024)
- Pickleball Warehouse — How to change your tennis overgrip (staff how-to; the same wrap steps apply to a paddle handle)
- JOOLA — How to re-grip your pickleball paddle, Game Ready episode 1 (September 18, 2025)
- PB5star — How to put overgrip on a pickleball paddle (Marisa Farnsworth, May 9, 2025)
- Pickleball Central — Paddle grips (grips vs overgrips)
- Pickleball Central — Franklin Pickleball Deluxe Overgrip (listing)
- Pickleball Central — Tourna Pickleball Cushion Replacement Grip (listing)
- Pickleball Central — HEAD Xtreme Soft Pickleball Over Grip (listing)
- Pickleball Central — How long do pickleball paddles last? A guide to paddle care (grip care)
- CRBN Pickleball — DryTec Overgrips (maker product page, 0.6 mm)
- Paddletek — AeroTac Pro Replacement Grip (maker product page, 1.9 mm)
- Merchant of Tennis — HEAD Hydrosorb Pro Pickleball Replacement Grip (listing, 1.75 mm)
- Gamma Sports — Get a grip: pickleball (Paige Powers, August 10, 2020)
Sources checked October 2026. Rules, fees and schedules change — confirm with the venue or governing body.